From here you can download version 3.10 of the Trimble GPScorrect extension for ESRI ArcPad software.
GPScorrect version 3.10 requires ArcPad version 7.1 or later. GPScorrect version 3.10 does not support earlier versions of ArcPad. ArcPad must be installed onto your PC or Windows Mobile device before you install the v3.10 GPScorrect extension.
A GPScorrect extension installation code can only be activated on one Windows Mobile (version 5.0 or 6) powered device at a time. If you activate an installation code on the wrong device or need to change the device the extension is activated on you will need to contact your Trimble Reseller to request it be deactivated.
Support for the Trimble GPS Pathfinder ProXRT receiver running firmware version 3.60 has been discontinued. You will need to update your receiver's firmware to version 3.72. For the firmware version 3.72 and instructions on how to upgrade your existing receiver firmware, go to http://www.trimble.com/pathfinderproxrt_ts.asp
Read the version 3.10 Release Notes for details on the new features and how to perform the installation.
- If you have a Software Maintenance Extension valid on or after 1 Dec 2009, you are entitled to v3.10. Use your existing installation code to install v3.10.
- If you do not have a Software Maintenance Extension valid on 1 Dec 2009, contact your local Trimble representative for details on upgrading to v3.10.
To post process data collected with the GPScorrect v3.10 extension, one of the following is required:
- Version 4.20 of the GPS Pathfinder Office software with the latest software updates.
- Version 2.20 of the GPS Analyst extension for ESRI ArcGIS software with the latest software updates.